Get Your Quote for AC Repair Near Me
Fill the form below to inquire about Gas Services Edmonton's AC Repair Near Me in Edmonton.
Fill the form below to inquire about Gas Services Edmonton's AC Repair Near Me in Edmonton.
We have seen every issue a residential cooling system can develop. Here are the problems our clients call us about most often.
Low refrigerant from a leak is the most common cause, reducing the system's ability to absorb and transfer heat out of the home. Running a low-charge system puts continuous stress on the compressor and worsens the fault over time. We test refrigerant pressure, locate the leak, seal it, and recharge the system to the correct specification.
Warm air from a running system usually points to a refrigerant issue, a frozen or dirty evaporator coil, or a compressor losing compression efficiency. Left unaddressed, the system continues to run at higher energy cost while delivering less cooling. We check all three causes in sequence so the correct repair is completed rather than a partial fix.
Grinding, squealing, banging, or persistent clicking from an AC unit typically indicates a failing fan motor, worn compressor components, a loose internal part, or a contactor not cycling cleanly. Ignoring these sounds usually leads to a more expensive repair once the affected component fails completely. Our technicians identify the source and repair or replace the faulty part before collateral damage occurs.
Short cycling is usually caused by a dirty evaporator coil blocking airflow, low refrigerant triggering a safety shutoff, or a control board fault sending incorrect signals to the system. A unit that short cycles cannot complete a full cooling cycle and wears out its components significantly faster. We diagnose the root cause and repair it rather than resetting the system and leaving the underlying problem in place.
Ice buildup on the evaporator coil or refrigerant lines results from restricted airflow, a dirty coil surface, or a low refrigerant charge that pulls coil temperature below freezing. Continuing to run a frozen system can damage the compressor and cause the fault to worsen. We thaw the system safely, identify the cause of the freeze, and complete the correct repair before restoring operation.
A system that does not respond at all often has a failed capacitor, a burned contactor, a tripped breaker tied to an internal electrical draw issue, or a faulty control board. The cause is not always visible from the outside, which is why testing the full electrical path through the unit matters before replacing parts. We diagnose the exact failure point and complete the repair with the correct components.
Restricted airflow is most commonly caused by a clogged air filter, a dirty evaporator coil reducing the air passage, or a failing blower motor not moving enough air through the system. Low airflow reduces cooling performance and forces the system to work harder, increasing wear across the unit. We locate where the restriction is occurring and correct it at the source rather than adjusting settings to compensate.
An unexplained increase in energy costs while cooling performance stays flat or drops is almost always a sign the system is working harder than it should. The most common causes are a low refrigerant charge reducing efficiency, dirty condenser coils limiting heat rejection, or a compressor drawing more current than normal. We test the system's efficiency and identify what is causing the added load so the repair addresses both the problem and the running cost.
Water inside the home near the air handler usually means the condensate drain is blocked with algae or debris, causing the collection tray to overflow. Some systems also have a float switch that shuts the unit down when this happens, which homeowners may interpret as a complete failure. We clear the drain, flush the line, and check that the safety switch is working correctly.
I called three companies before Gas Services Edmonton and was the only one that immediately offered to show their 313A certification without me having to ask twice. That alone told me who to trust with the job.
Our system died during the worst heat wave of the summer and they still got someone out that same afternoon. The technician diagnosed a failed capacitor and had it swapped within the hour.
The technician was upfront that our compressor part needed to be special-ordered, so it took an extra day. Communication throughout was excellent and the fix has been solid since it was installed.
I appreciated that the Gas Services Edmonton technician walked me through exactly what he was checking and why before starting any actual repair work. It felt transparent instead of a black box like other companies I've used before.
We had another company 'fix' the same issue twice before calling Gas Services Edmonton. They found the actual refrigerant leak the others missed and it hasn't come back since. Wish we had called them first.
The written quote matched exactly what we paid at the end, no hidden fees tacked on. Refreshing compared to a previous experience where the price crept up after the technician arrived.
Contact Gas Services Edmonton today for expert HVAC repair, installation, and maintenance services in Edmonton area.
Call us directly or send a message using the form, whichever works best for you.
CALL US (587) 805-0530 EMAIL US Click to send a messageContact us! Our conversation stays private.