Get Your Quote for AC Repair
Fill the form below to inquire about Gas Services Edmonton's AC Repair in Edmonton.
Fill the form below to inquire about Gas Services Edmonton's AC Repair in Edmonton.
We have seen every way a residential air conditioner can fail. Here are the problems our clients call us about most often and how we resolve them.
A system that runs continuously without cooling the space is usually dealing with a low refrigerant charge from a leak, a heavily fouled condenser coil, or a failing compressor. Running the system in this state accelerates component wear and can cause additional damage. We diagnose the specific cause before recommending any repair so the right problem is addressed, not just the most obvious component.
A system that will not start is most commonly caused by a failed capacitor, a tripped breaker, a faulty contactor, or a thermostat that is not sending a signal to the unit. Each of these has a different repair path and cost. We test the electrical circuit, components, and control signal systematically to identify the actual failure point before any part is ordered or replaced.
Ice formation on the evaporator coil is caused by restricted airflow, a low refrigerant charge, or both working together. A blocked filter, a closed return vent, or a refrigerant leak can all drop coil temperatures below freezing. We identify the cause, correct it, and thaw the coil before restarting the system to prevent coil damage from forced operation while frozen.
Grinding or squealing from an air conditioner usually points to a fan motor bearing that is failing, a belt that has deteriorated on older equipment, or debris that has entered the condenser fan housing. These sounds indicate metal-on-metal contact that will worsen quickly if the unit continues running. We identify the source and replace the affected component before the failure becomes more extensive.
Water leaking from the indoor air handler typically means the condensate drain is blocked, the drain pan has cracked, or the evaporator coil froze and is now thawing faster than the drain can handle. Left unaddressed, a water leak can damage flooring, ceiling materials, and the air handler cabinet. We clear or repair the drainage system and check for any secondary water damage before finishing the repair.
Short cycling, where the system starts and stops every few minutes, usually points to an oversized unit, a refrigerant overcharge or undercharge, a dirty condenser coil, or a faulty thermostat reading the temperature incorrectly. Repeated short cycles accelerate compressor wear and reduce dehumidification performance. We diagnose the specific cause and correct it to restore normal cycle length and protect the compressor.
Uneven cooling in specific areas usually indicates a duct that has come loose, a damper that has closed, a supply register that is blocked, or a system that was never correctly sized for the full space it is meant to cool. We check duct integrity, airflow at each register, and system capacity before recommending any repair or adjustment to ensure the fix addresses the real cause.
When the outdoor condenser unit is completely silent, the most common causes are a failed contactor, a tripped high-pressure switch, or a compressor that has seized. Without the condenser running, no heat rejection happens and the system cannot produce cooling. We check the contactor, control board signals, and compressor condition to confirm which component needs attention.
A burning odour from the vents or the air handler typically signals overheating motor windings, a failed capacitor burning out, or an electrical fault inside the unit. This symptom should not be ignored or attributed to normal operation. We shut the system down safely, identify the source of the burning, and repair or replace the affected component before it becomes a fire risk.
Our AC was blowing warm air and I expected a simple capacitor swap. The technician actually found a refrigerant leak at a fitting that a previous company had missed entirely. Gas Services Edmonton fixed it properly and it's been running perfectly since.
Our system died on one of the hottest days of the summer and they still got someone out same day. The tech diagnosed a failed contactor and had it replaced within the hour. Genuinely relieved it wasn't a bigger issue.
The diagnostic was thorough and honest, but our compressor part needed to be special-ordered so we waited an extra day. The Gas Services Edmonton technician kept us updated the whole time and the fix has held up perfectly since.
I called expecting another repair bill but the technician was upfront that our 14-year-old unit's compressor failure wasn't worth fixing. Saved us from throwing money at a system that was on its way out anyway.
We kept getting ice on the lines and a previous company just cleared it without explaining why. Gas Services Edmonton traced it to a dirty filter restricting airflow and it hasn't happened again since the fix.
The grinding sound turned out to be a worn fan motor bearing. The technician explained exactly what was happening before starting the repair and the system is dead silent now. Wish we had called sooner instead of waiting.
Contact Gas Services Edmonton today for expert HVAC repair, installation, and maintenance services in Edmonton area.
Call us directly or send a message using the form, whichever works best for you.
CALL US (587) 805-0530 EMAIL US Click to send a messageContact us! Our conversation stays private.