Get Your Quote for Air Conditioning Service
Fill the form below to inquire about Gas Services Edmonton's Air Conditioning Service in Edmonton.
Fill the form below to inquire about Gas Services Edmonton's Air Conditioning Service in Edmonton.
A proper air conditioning service goes well beyond a filter swap. Here are the conditions we find and correct most often during annual maintenance visits.
A refrigerant level that has drifted below the manufacturer's specification reduces cooling capacity and puts the compressor under additional strain with every cycle. Most homeowners do not notice until the system cannot keep up during the hottest days of the year. We measure system pressures at both service ports and correct the charge if it has fallen outside the correct range.
The outdoor condenser coil collects grass clippings, cottonwood, dust, and airborne debris with every season it runs. A coated coil cannot reject heat to the outdoor air efficiently, which raises refrigerant pressure and forces the compressor to work harder. We clean the coil surface during every service visit to restore full heat rejection capacity.
Capacitors degrade gradually over years of use, and a capacitor at reduced capacity puts strain on the motor it supports even though the system still appears to be functioning normally. Testing during annual service catches a weakening capacitor before it causes a mid-season breakdown. We replace it proactively when the reading falls outside the acceptable tolerance.
Algae and mold growth in the condensate drain line is a natural byproduct of a system that produces moisture continuously during cooling season. A blocked drain causes water to back up into the air handler tray and can shut the system down entirely via the float safety switch. We flush the drain line and treat it to slow regrowth as part of the standard service.
A blower motor that is drawing more current than its rated range is signaling that something is creating resistance: a dirty wheel, a failing bearing, or a motor that is beginning to wind down. Left unaddressed, the motor eventually fails and takes cooling with it. We measure motor amp draw during each service visit and flag motors that are trending outside their normal operating range.
A thermostat that reads the room temperature incorrectly by even a few degrees will cause the system to cycle too early or run too long, wasting energy and reducing comfort. This is particularly common in older mechanical thermostats and in smart thermostats that have lost indoor sensor calibration. We verify thermostat accuracy and correct the calibration setting during the service visit.
High-pressure and low-pressure safety switches are designed to shut the system down before a pressure fault damages the compressor. A switch that has drifted out of calibration or stopped responding correctly provides no protection when the system needs it most. We test both safety controls during every air conditioning service to confirm they will trip at the correct pressure points.
The evaporator coil collects fine dust and airborne particles that pass through or around the air filter over multiple seasons. A coated coil surface restricts the heat transfer between the coil and the indoor air, which causes the coil to run colder than intended and eventually freeze. We inspect and clean the evaporator coil during service to restore proper airflow and heat absorption.
A musty or stale odour when the AC runs is usually caused by biological growth on the evaporator coil or in the drain pan, both of which stay damp during normal operation. This is a common sign that the system has gone one or more seasons without a proper cleaning. We eliminate the source of the odour during the service visit rather than masking it.
Booked our spring tune-up with Gas Services Edmonton and the technician found a capacitor that was already reading out of range. Replaced it on the spot instead of letting it fail in July. Exactly the kind of thing I wanted caught early.
The technician walked through the whole checklist, from coil cleaning to refrigerant checks, and showed me the fin comb work on the outdoor unit. Never felt rushed and left with a written report I can keep for our records.
Our system hadn't been serviced in a few years so the visit took closer to two hours instead of the estimated ninety minutes. Understandable given the buildup, and the AC has been running noticeably better since.
We have a three-zone mini-split and Gas Services Edmonton was upfront that it would take longer than a standard central air visit. Each head got individual attention and the airflow difference afterward was noticeable in every room.
Had our AC serviced for the first time in three years and our cooling bill dropped noticeably compared to last summer. The technician explained the dirty coil was likely the main culprit. Booking annually from now on.
Didn't realize our manufacturer warranty required documented annual maintenance until Gas Services Edmonton mentioned it during the visit. Glad we started keeping records now instead of finding out the hard way during a claim.
Contact Gas Services Edmonton today for expert HVAC repair, installation, and maintenance services in Edmonton area.
Call us directly or send a message using the form, whichever works best for you.
CALL US (587) 805-0530 EMAIL US Click to send a messageContact us! Our conversation stays private.