Get Your Quote for Emergency Air Conditioning Repair
Fill the form below to inquire about Gas Services Edmonton's Emergency Air Conditioning Repair in Edmonton.
Fill the form below to inquire about Gas Services Edmonton's Emergency Air Conditioning Repair in Edmonton.
We've seen every way an air conditioner can fail. Here are the problems our clients call us about most when cooling stops and they need help fast.
This is most commonly caused by a failed capacitor, which prevents the compressor from running at full capacity even though the fan continues operating. Left unchecked, the compressor takes on increased strain with every start attempt and may fail entirely. We test the capacitor, contactor, and compressor on arrival and replace the faulty component the same visit in most cases.
A circuit breaker that trips each time the AC starts usually points to an electrical fault inside the unit, such as a shorted capacitor, a grounded compressor winding, or a wiring problem drawing excess current. Continuing to reset the breaker and retry can cause further damage to the electrical components. We perform a safe electrical diagnostic to find the root cause before recommending any repair.
Ice buildup on the refrigerant lines or evaporator coil is typically caused by restricted airflow from a clogged filter or dirty coil, or by low refrigerant that drops the coil temperature below freezing. A frozen coil blocks heat transfer entirely, stopping cooling even while the system runs. We identify whether the cause is airflow or refrigerant and correct both the immediate blockage and the underlying issue.
When the outdoor condenser unit is completely silent, the most common causes are a failed contactor, a tripped high-pressure switch, or a compressor that has seized. Without the condenser running, no heat rejection happens and the system cannot produce cooling. We check the contactor, control board signals, and compressor condition to confirm which component needs attention.
A slow refrigerant leak gradually reduces the system's ability to absorb and move heat, resulting in longer run times, higher indoor temperatures, and eventually no cooling at all. Running a system with low refrigerant accelerates wear on the compressor and increases energy consumption. We locate the leak, repair the source, and recharge the system to the correct specification.
A burning odour coming from the vents or the air handler typically signals overheating in the motor windings, a failed capacitor burning out, or an electrical issue inside the unit. This symptom should not be ignored or attributed to normal operation. We shut the system down safely, identify the source of the burning, and repair or replace the affected component before it becomes a fire risk.
A system that starts and stops frequently within a few minutes is short cycling, which is usually caused by an oversized unit, a refrigerant pressure issue, a dirty condenser coil overheating the system, or a failing thermostat sending incorrect signals. Short cycling prevents the space from cooling properly and puts rapid wear on the compressor. We diagnose the cause of the cycling pattern and correct it at the source.
When an AC blows air but the air is warm or only slightly cool, the compressor may not be engaging, refrigerant may be critically low, or the thermostat may be sending the wrong mode signal. This symptom sometimes looks like a minor issue but can indicate a compressor failure developing. We confirm the refrigerant charge, test the compressor start sequence, and check the thermostat and control board before drawing conclusions.
Systems that fail during extreme heat are often pushed past a component that was already near the end of its life, most commonly the capacitor or contactor. High ambient temperatures stress every part of the system harder than normal operating conditions. We arrive prepared with common replacement parts for same-day repairs so you are not left without cooling overnight.
Our AC died during a heat warning and I called three other companies that just went to voicemail. Gas Services Edmonton picked up right away and had someone out within ninety minutes. Fixed a bad capacitor on the spot.
The dispatcher explained the after-hours rate clearly before anyone came out, no surprises. Compressor was fine, just a failed contactor. In and out in under an hour.
They diagnosed a refrigerant leak the same night but the specific fitting had to come from the shop the next morning. They kept the system stable in the meantime and finished the repair first thing. Would call again.
My mother lives with us and has a heart condition, so a dead AC during a heat wave was genuinely scary. Gas Services Edmonton treated it as the emergency it was and had a technician here within the hour.
I half expected a rushed job given it was 1 a.m., but the technician was just as thorough as any daytime appointment I've had. Explained everything and tested the system before leaving.
The dispatcher actually told us our situation could safely wait until morning since no one in the house was at risk, saving us the after-hours rate. Appreciated the honesty from Gas Services Edmonton more than a company that would have just sent someone out.
Contact Gas Services Edmonton today for expert HVAC repair, installation, and maintenance services in Edmonton area.
Call us directly or send a message using the form, whichever works best for you.
CALL US (587) 805-0530 EMAIL US Click to send a messageContact us! Our conversation stays private.