Get Your Quote for Emergency HVAC Service
Fill the form below to inquire about Gas Services Edmonton's Emergency HVAC Service in Edmonton.
Fill the form below to inquire about Gas Services Edmonton's Emergency HVAC Service in Edmonton.
Every HVAC system has its pressure points. Here are the failures our clients call us about most urgently, and how we resolve them.
The most common winter emergency call. Usually caused by a failed ignitor, a tripped high-limit switch, or a faulty flame sensor that cannot confirm the burner is lit. Each of these prevents the furnace from completing its startup sequence. We diagnose the exact failure point and replace the component on the same visit in most cases.
A CO alarm linked to a gas furnace or boiler is always treated as an emergency. The most common causes are a cracked heat exchanger, a blocked flue, or incomplete combustion from a burner problem. We evacuate the cause systematically, inspect the heat exchanger and venting thoroughly, and do not clear the system until we are confident it is safe.
Complete AC failure during a heat wave is dangerous for vulnerable household members. Common causes include a failed capacitor, a seized compressor, a refrigerant leak, or a tripped disconnect. We diagnose the specific failure, carry common parts on the vehicle, and restore cooling as quickly as the repair allows.
A furnace that runs but produces no heat usually has a burner ignition failure, a tripped rollout sensor, or an open limit switch from restricted airflow. The blower continues to run but no combustion is occurring. We trace the failure to its source and restore proper heating operation.
Unexpected shutdowns are often caused by a safety device tripping in response to a real condition: overheating, airflow restriction, refrigerant pressure out of range, or a faulty pressure switch. Resetting the system without diagnosing the cause means it will shut down again. We find the condition that triggered the safety device and correct it properly.
A burning smell from the furnace or air handler is a sign of overheating, an electrical fault, or debris in the heat exchanger. It should not be dismissed as normal startup smell if it continues for more than a few minutes. We inspect the electrical components, heat exchanger, and airflow path to identify the source and assess whether continued operation is safe.
Partial heat loss often points to a zoning issue, a stuck damper, a failed zone valve, or a blocked supply line rather than a whole-system failure. It can also indicate an oversized system that is short-cycling. We diagnose at the system level and at the zone level to find the actual cause before recommending a fix.
A gas smell near heating equipment is always treated as an emergency. The source may be a failed gas valve, a loose appliance connection, or a gas line fitting that has vibrated loose near the equipment. We shut off the gas supply, locate the source, make the repair, and pressure test before restoring service.
A blank thermostat with an unresponsive HVAC system often points to a tripped furnace breaker, a blown control board fuse, or a communication fault between the thermostat and the air handler. This is easy to misread as a major system failure when it may be a quick fix. We trace the full control circuit from the thermostat through to the system board to find where the signal stops.
Our furnace died the coldest night of the year and I panicked, but Gas Services Edmonton had someone here within two hours. The technician found a cracked igniter and had it replaced before I even finished making coffee. Genuinely grateful they picked up at that hour.
I called in a bit of a panic about a faint gas odor near the furnace. The dispatcher walked me through leaving the house immediately and had a technician there quickly. Turned out to be a loose fitting, fixed on the spot, and I felt so much better once it was confirmed safe.
Our AC compressor failed during a heat warning with my elderly mother staying with us. Gas Services Edmonton's technician diagnosed it fast but the replacement part had to come from a supplier the next morning, so we ran a portable unit overnight. Once it arrived, the fix was quick and it has run perfectly since.
Heat went out overnight in January and I did not realize how fast pipes could freeze until Gas Services Edmonton explained it on the phone. They got someone out within an hour and the furnace was running again before any real damage happened. That phone call alone probably saved us thousands.
I expected to be told I needed a whole new furnace given how old ours is, but the technician explained it was just a failed flame sensor and had it swapped in under an hour. Straightforward pricing with no upsell attempt at all.
Our AC kept tripping the breaker and I assumed it was electrical, but the technician traced it back to a failing compressor before it got worse. Explained everything clearly and had a replacement scheduled fast. Would call them again without hesitation.
Contact Gas Services Edmonton today for expert HVAC repair, installation, and maintenance services in Edmonton area.
Call us directly or send a message using the form, whichever works best for you.
CALL US (587) 805-0530 EMAIL US Click to send a messageContact us! Our conversation stays private.